Iei door gard 212i manual

IEI recommends using a filtered and regulated power supply When mounting the w outside, use a weatherproof back box and apply silicone to the area where the wires enter the case. Also, provide a weep hole at the bottom of the back box to prevent condensation from collecting on the circuit board. This keypad is not for use in extreme. Affordable single door access control keypad designed to meet the indoor flush mount needs of lighter volume access control environments. There are three LED’s to indicate operation status and provide the user with visual PIN entry confirmation. The i style keypad mounts to most standard single-gang electrical back boxes. Specifications. two keypads to control a single door. Entering your code on keypad 2 unlocks the maglock directly. When you enter your code on keypad 1, it triggers the REX input of keypad two, which unlocks the door Please note that user codes must be programmed into both keypads Rev 1 TECHNICAL NOTES This product was re-designed using a new.

For over 30 years, Linear's IEI brand has built its reputation based on trusted products and responsiveness to customers. With a range of access control solutions, including the market leading Door-Gard stand alone keypad line, Linear offers customers the right solution for their application and combines that solution with a commitment to excellence in service and support. IEI e StandaloneTM Keypad Installation/ Programming Manual Contents Section 1: Features and Product Description Features Product Description Section 2: U.L. Requirements Section 3: Specifications Section 4: Mounting Section 5: Wiring Wire Harness Configuration Wiring the e Keypad to a Maglock (Fail-Safe). IEI W Indoor / Outdoor Flush-mount Weather Resistant Membrane Keypad UPC: Also known as: IEW The IEIW is a single-door keypad for light volume access control environments both indoors and out. The keypad is covered by a sealed membrane that protects the keys from moisture and allows the unit to be easily cleaned.

door loop doesn’t need to be closed for the REX function to operate, by default, but setting option 8 to 0 under command 30, programs the REX function to operate only when the door loop is closed. This prevents the REX from re-triggering when the door is open. Figure 8 Wiring a REX Button and Door Contacts. Affordable single door access control keypad designed to meet the indoor flush mount needs of lighter volume access control environments. There are three LED’s to indicate operation status and provide the user with visual PIN entry confirmation. The i style keypad mounts to most standard single-gang electrical back boxes. Specifications. Today I Will change the codes on an IEI I Keypad.